cummins recommends the use of RtV (cummins P/n 3823494) between the rocker housing and the spacer. Seal must be located on the outside of the spacer. Some restrictions apply see limited warranty details or call for more information. Install bulkhead fitting with seal into hole in spacer as shown in Fig. So, I found something on the internet that I want to use as a starter.
how to threads for the DIYers, but nothing really on torque specs for bolts. Off-Road All configurations: 1yr/2,000 hours. Thermostat housing retaining bolts 23 17 Coolant pump mounting bolts 23 17. On 07.5-12 6.7L trucks equipped with the Bosch CP3 you will use it to replace the banjo fitting at the back of the stock fuel filter. TS6000 Cummins Rear Crankshaft Seal Tool Set Quickly & easily replace that leaky rear crankshaft seal on your 1989-current Cummins 5.9L or 6. Every engine is run through a warm up cycle three separate cruise segments simulating light, medium and heavy throttle conditions maximum torque and horsepower tests both high and low idle tests and a black light leak detection test with dyed oil, coolant and fuel. On 98.5-02 trucks equipped with the Bosch VP44 injection pump and 03-07 equipped with the Bosch CP3 injection pump this bolt replaces the banjo bolt on the fuel supply line. Computer controls ensure that each engine dyno test is conducted under standard, repeatable settings. REVIVA’S DYNO TESTĪll of Reviva’s Complete Drop-In engines are 100% dyno tested prior to shipment.
The CPL and serial numbers are located on the valve cover. Before calling to request price and availability, please gather the following information: